NX Tip
of the Week
February
27, 2015
|
NX -
Chamfering Multiple Hole Sizes in NX CAM
|
Sometimes you may have parts that have holes with different
diameters and also different chamfer sizes. There is a new operation in NX
CAM that can simplify chamfer operations. The new Hole Chamfer Milling
operation can easily chamfer a variety of diameters and chamfer sizes. The
Hole Chamfer Milling operation is new in NX10 although it was actually
released in a later Maintenance Release of NX9 (NX9.0.2). The example below
illustrates how to use the new operation.
1) In the part shown below you will notice holes that
vary in diameter and chamfers with different depths:
|
2) When defining the
tool make sure the diameter is smaller that the smallest hole you will be
chamfering and also be sure to define the tracking point:
3) Select Hole
Chamfer Milling operation:
4) Specify Feature
Geometry by selecting the holes to chamfer:
5) Generate the
operation and notice each of the holes have been chamfered:
No comments:
Post a Comment